Fujitsu Eternus DX90 S2 - Page 274

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-affinity
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
274
The available combinations for optional parameters are shown below.
No: Not available R: Required Yes: Available (the options can be omitted) *: Either one of these options
must be specified
*1: Both of the parameter combinations can be omitted when a path is set in a host affinity that is already set with a
port group. Therefore, an error occurs when an affinity group is not specified and the port group and the host group
are not associated with the host affinity setting.
*2: The "-ag-number" parameter or the "-ag-name" parameter cannot be specified when LUN mapping is already set
with a port group and the host response for LUN mapping will be changed. Therefore, a host response must be
specified when an affinity group is not specified ("Default" must be specified to set the default host response).
-ag-number
or
-ag-name
(When this parameter is used with the "-port-group-number" or the "-port-group-name"
parameter) Optional. This parameter specifies the affinity group identifiers that will be
associated. Only one parameter can be specified at the same time. For details, refer to "1.2.11
Affinity Group Syntax" (page 24).
-lg-number
or
-lg-name
(When this parameter is used with the "-port-group-number" or the "-port-group-name"
parameter) Optional. This parameter specifies the LUN group identifiers that will be
associated. Only one parameter can be specified at the same time. For details, refer to "1.2.11
Affinity Group Syntax" (page 24).
-host-group-number
or
-host-group-name
or
-host-response-number
or
-host-response-name
This parameter specifies the host group number, the host group name, the host response
number, or the host response name. Only one host group or host response can be specified at
the same time. For details, refer to "1.2.12 Host Response Syntax" (page 24)
and "1.2.16 Host
Group Syntax" (page 26).
Parameter
-port -ag-number (-lg-number) -ag-name (-lg-name) -host-number -host-name -port-group-number -port-group-name -host-group-number -host-group-name -host-response-number -host-response-name
-port — * (*1) * NoNoNoNoNoNo
-ag-number (-lg-number) R — No * NoNoNoNoNoNo
-ag-name (-lg-name) R No — * NoNoNoNoNoNo
-host-number R * (*1) — NoNoNoNoNoNoNo
-host-name R * (*1) No — NoNoNoNoNoNo
-port-group-number No * No No — No * *
-port-group-name No * No No No — * *
-host-group-number No * NoNo * — NoNoNo
-host-group-name No * No No * No — No No
-host-response-number No * (*2) No No * No No — No
-host-response-name No * (*2) No No * No No No —