Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > release host-affinity
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
278
The available combinations for optional parameters are shown below.
No: Not available R: Required Yes: Available (the options can be omitted) *: Either one of these options
must be specified **: Either one of these options is available
■ Example(s)
Parameter
-port xyz
-port all
-host-number
-host-name
-port-group-number
-port-group-name
-host-group-number
-host-group-name
-port xyz — — ** NoNoNoNo
-port all — — NoNoNoNoNoNo
-host-number R No — NoNoNoNoNo
-host-name R NoNo — NoNoNoNo
-port-group-number No No No No — No **
-port-group-name No No No No No — **
-host-group-number No No No No * — No
-host-group-name No No No No * No —
The following example releases all of the host affinity settings that have been made on host interface CA#0
Port #0 on CM#1:
CLI> release host-affinity -port 100
The following example only releases the host affinity settings of the host named "H1" on CA#0 Port #1 on
CM#0:
CLI> release host-affinity -port 001 -host-name H1
The following example releases the host affinity settings of the host named "H1" on host interface CA#1
Ports #0 and #1 on CM#0:
CLI> release host-affinity -port 010,011 -host-name H1
The following example respectively releases the host affinity settings of the host named "H1" and "H2" on
CA#0 ports #0 and #1 on CM#1:
CLI> release host-affinity -port 100,101 -host-name H1,H2
The following example respectively releases the host affinity settings of host #1 and #2 on the host interface
CA#0 Port#0 on CM#0:
CLI> release host-affinity -port 000 -host-number 1,2
To Next Page
Loading...
