Fujitsu Eternus DX90 S2 - Page 313

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set port-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
313
■ Example(s)
The following example changes the port group named "PG001". The new name is "NEW_PG002":
CLI> set port-group -port-group-name PG001 -name NEW_PG002
The first command will create the port group named "PG0001". This port group will contain FC interface port
#1 on CM#0 CA#0 and FC interface port #1 on CM#0 CA#1.
The second command will add other definitions to the port group named "PG0001". FC interface port #1 on
CM#1 CA#0 and FC interface port #1 on CM#1 CA#1 are added to the port group:
CLI> create port-group -port-group-name PG0001 -port 001,011
CLI> set port-group -port-group-name PG0001 -add-port 101,111