Fujitsu Eternus DX90 S2 - Show Host-Lu-Qos-Mode

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-lu-qos-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
328
show host-lu-qos-mode
This command displays the setting status of the Host-LU QoS function.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show host-lu-qos-mode
# Host-LU QoS Mode [Enable]
A
A: Setting status of the Host-LU QoS Mode
The following example displays the setting status of the Host-LU QoS function:
CLI> show host-lu-qos-mode
Host-LU QoS Mode [Disable]
CLI> show host-lu-qos-mode
Host-LU QoS Mode [Enable]