Fujitsu Eternus DX90 S2 - Set Host-Lu-Qos

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-lu-qos
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
334
set host-lu-qos
This command performs detailed settings for the Host-LU QoS function. This command can change the QoS
settings for Port QoS, Host QoS, and LU QoS.
■ Syntax
■ Parameter
set host-lu-qos -mode {port-qos|host-qos|lu-qos}
{-port {
xyz |all} [-bandwidth-limit bandwidth-limits ] [-event-number event-numbers ]
[-schedule-number
schedule-numbers ]}
{-host-type {fc|iscsi|sas} {-host-number
host_numbers | -host-name host_names }
[-bandwidth-limit
bandwidth-limits ] [-event-number event-numbers ]
[-schedule-number
schedule-numbers ]}
{-port
xyz [{-host-number host_numbers | -host-name host_names }]
[-lu-qos-group
lu_qos_group_numbers ] [-event-number event_numbers ]
[-schedule-number
schedule_numbers ]}
-mode This parameter specifies which QoS settings are changed.
port-qos Port QoS
host-qos Host QoS
lu-qos LU QoS
-port This parameter specifies the host interface port when Port QoS or LU QoS is set.
Example: -port 00
For details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
• When "lu-qos" is specified for the "-mode" parameter, "all" cannot be specified.
• When "lu-qos" is specified for the "-mode" parameter, the type (FC, iSCSI, SAS) of all the
ports that are specified by the "-host-number" or "-host-name" parameter must be the
same.