Fujitsu Eternus DX90 S2 - Show Radius

Chapter 4 Function/System Settings and Display
4.1 User Management > show radius
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
376
show radius
This command displays the settings of the RADIUS server.
■ Syntax
■ Parameter
No parameters.
■ Output
show radius
# RADIUS authentication [Enable]
A
# After error [No
]
B
# Primary server [10.21.134.198]
C
# Primary port [MNT
]
D
# Primary port number [1812
]
E
# Primary authentication mode [CHAP]
F
# Primary shared secret [xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
]
G
# Primary retry timeout [20
]
H
# Secondary server [10.17.80.6]
I
# Secondary port [RMT
]
J
# Secondary port number [1912
]
K
# Secondary authentication mode [PAP]
L
# Secondary shared secret [yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy]
M
# Secondary retry timeout [20
]
N
A: Mode. Display the system's mode.
B: Displays which method used after found error.
C: FQDN or IP address (IPv4 or IPv6) of the primary authentication server.
D: Port that is used for primary settings.
E: Port number of the primary authentication server for the authentication protocol.
F: Authentication method type of the primary authentication server.
G: Shared secret of the primary authentication server.
H: Retry timeout value of the primary authentication server.
I: FQDN or IP address (IPv4 or IPv6) of the secondary authentication server
J: Port that is used for secondary settings.
K: Port number of the secondary authentication server for the authentication protocol.
L: Authentication method type of the secondary authentication server.
M: Shared secret of the secondary authentication server.
N: Retry timeout value of the primary authentication server.