Fujitsu Eternus DX90 S2 - Show Advanced-Copy-Parameters

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show advanced-copy-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
393
show advanced-copy-parameters
This command displays the current settings of the Advanced Copy parameters.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show advanced-copy-parameters
# Resolution [x2]
A
# Advanced Copy Table Size [128MB]
B
# EC/OPC Priority [Auto]
C
# Current EC/OPC Priority [Low Priority]
D
# SDPE [1GB]
E
# Advanced Copy Table Usage Threshold [80%]
F
# Used Advanced Copy Table Size [30MB]
G
# Usable Advanced Copy Size [20GB]
H
# Copy Schedule Mode [Session balancing]
I
A: Resolution
B: Advanced Copy table size
C: EC/OPC priority and EC/OPC rate mode that is currently set in the system (Example: Auto, Very Low Priority, Low
Priority, Middle Priority, High Priority)
D: EC/OPC priority that is currently used
E: Resolution of a snap data pool volume
F: Threshold value of the Advanced Copy table usage
G: Advanced Copy table size that is currently used
H: Usable Advanced Copy table size
I: Copy Schedule Mode (Example: Session balancing, Destination RAID Group balancing)
The following example displays the Advanced Copy parameters:
CLI> show advanced-copy-parameters
Resolution [x2]
Advanced Copy Table Size [128MB]
EC/OPC Priority [Auto]
Current EC/OPC Priority [Low Priority]
SDPE [1GB]
Advanced Copy Table Usage Threshold [80%]
Used Advanced Copy Table Size [30MB]
Usable Advanced Copy Size [20GB]
Copy Schedule Mode [Session balancing]