Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show advanced-copy-sessions
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
404
When details are displayed:
# SID Gene- Type Volume Source Volume Destination Volume Status Phase Error Requestor
# ration Type No. Name No. Name Code
# 3 - EC Standard 8004 VOLUME001 4004 VOLUME002 Active Equivalent 0x00 GUI
A B C D E F G H I J K L
Source Block Address (LBA) : 0x1234567890123456
M
Destination Block Address (LBA): 0x1234567890123456
N
Total Data Size(MB) : 1024
O
Copied Data Size(MB) : 512
P
Modified Data Size(MB) : -
Q
SDP Used Capacity(MB) : -
R
SDP-ID (assigned to SDV) : -
S
Direction : -
T
Sync : -
U
Transfer Mode : -
V
Recovery Mode : -
W
Split Mode : -
X
Remote Session-ID : -
Y
Remote Box-ID : -
Z
Time Stamp : 2010-11-17 18:30:00
a
Elapsed Time : 1 day 1 hour 32 min 35 sec
b
Resolution : x2
c
License : Regular
d
Copy Range : Extent
e
Secondary Access Permission : No Read/Write
f
Concurrent Suspend Status : Normal
g
Change Error : Normal
h
Remain Time : 1 day 1 hour 32 min 35 sec
i
A to L: Refer to the above information when a list is displayed.
M: The copy source Start Logical Block Address (LBA) in the specified range is displayed in 16-digit hexadecimal.
N: The copy destination Start LBA in the specified range is displayed in 16-digit hexadecimal.
O: Total Data Size is displayed.
P: Copied Data Size is displayed.
Q: Modified Data Size is displayed.
R: Used Snap data pool capacity is displayed when the type SnapOPC or SnapOPC+ is selected.
S: Snap data pool ID that is assigned to SDV is displayed when the type SnapOPC or SnapOPC+ is selected.
T: In the relevant copy session, the direction of the copy is displayed when the type REC is selected (Primary: copy
source, Secondary: copy destination).
U: Operation mode of the session is displayed.
Sync: Synchronous Operation Mode
Async: Asynchronous Operation Mode
V: Transfer mode of the session is displayed. Details are as follows:
Through Mode: Asynchronous Through Mode
Stack Mode: Asynchronous Stack Mode
Consistency Mode: Asynchronous Consistency Mode
W: The recovery mode of the session is displayed only when the type REC is selected.
Automatic: A mode to restart copying automatically when the REC copy path has recovered from abnormal
status.
Manual: A mode not to restart copying automatically when the REC copy path has recovered from abnormal
status.
To Next Page
Loading...
