Chapter 4 Function/System Settings and Display
4.3 Network Management > show network
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
458
show network
This command displays the Ethernet configuration parameters.
■ Syntax
■ Parameter
No parameters.
■ Output
show network
# MNT port Enable
Maintenance port name (MNT port) and [Enable/Disable]
# IPv4 Enable
Whether IPv4 settings are enabled or disabled [Enable/Disable]
# Master IP 192.168.1.1
IP address of MNT port on master CM
# Slave IP 192.168.1.2
IP address of MNT port on slave CM
This is not displayed for a single-controller type.
# Subnet Mask 255.255.255.0
Subnet mask of MNT port
# Gateway 192.168.1.250
Gateway address of MNT port
# Primary DNS 192.168.1.253 Secondary DNS 192.168.1.254
Primary and secondary DNS IP address
# Speed and Duplex Auto Negotiation
Connection speed of MNT port
# Allowed IP1 192.168.2.0,255.255.255.0 Allowed IP2 10.10.10.0,255.255.255.0
IP address Subnet mask IP address Subnet mask
...
# Allowed IP15 192.168.9.0,255.255.255.0 Allowed IP16 10.10.17.0,255.255.255.0
IP address Subnet mask IP address Subnet mask
The list of Allowed IP1-16 is accessible terminals through MNT port.
# Wake on LAN Disable
It indicates if a function of the Wake on LAN is enabled on the MNT port.
# Ipv6 Enable
Whether IPv6 settings are enabled or disabled [Enable/Disable]
# Master Link Local IP fe80:2:3:4:5:6:7:8
Link local IP address (Master)
# Master Connect IP 1:2:3::6:7:8
Connect IP address (Master)
# Slave Link Local IP fe80:b:c:d:e:f:10:11
Link local IP address (Slave). This is not displayed for the single-controller
type.
# Slave Connect IP a:b:c:d::
Connect IP address (Slave). This is not displayed for the single-controller
type.
# Length of Subnet Prefix 64
Prefix length
# Gateway c0:a8:1:fa:ff:ff:ff:0
Gateway
To Next Page
Loading...
