Chapter 4 Function/System Settings and Display
4.3 Network Management > show firewall
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
466
show firewall
This command displays the status of each Ethernet application service port.
■ Syntax
■ Parameter
No parameters.
■ Output
show firewall
# MNT Port
# http [Closed]
# https [Closed]
# telnet [Closed]
# SSH [Open ]
# Maintenance-Secure [Closed]
# ICMP [Closed]
# SNMP [Closed]
# RCIL [Closed]
# IP Redirect Test [Closed]
#
# RMT Port
# http [Closed]
# https [Closed]
# telnet [Closed]
# SSH [Open ]
# Maintenance-Secure [Closed]
# ICMP [Closed]
# SNMP [Closed]
#
# FST Port
# http [Closed]
# https [Closed]
# telnet [Closed]
# SSH [Open ]
# Maintenance-Secure [Closed]
# ICMP [Closed]
MNT port: Maintenance Ethernet port. RMT port: Remote Ethernet port. FST port: FST Ethernet port. The port
status of application service http, https, telnet, SSH, ETERNUS Maintenance Secure, ICMP, SNMP, RCIL (MNT
port only), and IP forwarding (MNT port only) are displayed respectively. [Open ] indicates that the port is
opened. [Closed] indicates the port is closed.
FST port information is not supported in ETETNUS DX80 S2/DX90 S2.
To Next Page
Loading...
