Fujitsu Eternus DX90 S2 - Create Snmp-Manager

Chapter 4 Function/System Settings and Display
4.3 Network Management > create snmp-manager
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
472
create snmp-manager
This command sets IP address to receive SNMP traps in the SNMP manager setting. Since the ETERNUS DX Disk
storage system has 10 entries, up to 10 settings can be specified. A new SNMP manager setting will be the
lowest number.
■ Syntax
■ Parameter
■ Example(s)
create snmp-manager -ip-address ip_address
-ip-address This parameter specifies the SNMP manager IP address. To specify the SNMP manager IP
address, use IPv4 standard notation (a base 256 "d.d.d.d" string) or the IPv6 format. The
SNMP manager IP address cannot be specified with a fully qualified domain name (FQDN).
The types of IPv6 addresses that can be specified are global addresses (including 6to4
addresses), link local addresses, and unique local addresses.
Example: -ip-address 192.168.1.20
Example: -ip-address fe80::1b:332f:d0
The following example creates SNMP manager to set IP address 10.0.0.1:
CLI> create snmp-manager -ip-address 10.0.0.1