Chapter 4 Function/System Settings and Display
4.3 Network Management > delete community-profile
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
495
delete community-profile
This command deletes an SNMP community profile and/or deletes SNMP managers from community profile.
This command is not available when the SNMP manager setting that is to be deleted is already used for an
SNMP trap.
■ Syntax
■ Parameter
■ Example(s)
• The community-profile "community4" has 3 manager settings #1 – #3.
• When deleting all of the settings using "-manager-numbers 1-3", not only the manager settings on the
profile setting, but also the community profile are deleted.
• The result is the same as when "-community community4" is specified.
delete community-profile -community
community_name
[-manager-number
manager_numbers
]
-community This parameter specifies the SNMP community name of profiles to be deleted. Only one
community name can be specified at the same time.
-manager-number
Optional. This parameter specifies the manager number.
Any value between 1 and 10 can be specified. This number can be confirmed by using the
"show snmp-manager" command. One or more numbers can be specified by using "," or "-". If
omitted, all the profiles that contain the specified SNMP community name are deleted.
The following example deletes all the SNMP community profiles whose name is "community1":
CLI> delete community-profile -community community1
The following example deletes SNMP manager number 4 from community2:
CLI> delete community-profile -community2 -manager-number 4
To Next Page
Loading...
