Fujitsu Eternus DX90 S2 - Delete Snmp-Trap

Chapter 4 Function/System Settings and Display
4.3 Network Management > delete snmp-trap
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
500
delete snmp-trap
This command deletes the SNMP trap that corresponds to an SNMP community. This command deletes the
trap, but does not delete the specified SNMP community.
■ Syntax
■ Parameter
■ Example(s)
delete snmp-trap -trap-number trap_numbers
-trap-number
This parameter specifies the setting trap number. The trap number can be confirmed using the
"show snmp-trap" command.
The following example deletes SNMP trap numbers 2-4:
CLI> show snmp-trap
Trap SNMP Manager IP Community User Port
No. Version Number Address Name Name Number
1 v1 1 192.168.100.250 "community1" 162
2 v2c 2 192.168.2.1 "community2" 162
3 v3 3 10.0.0.1 "User1" 162
4 v3 4 192.168.100.101 "user_four" 8162
5 v3 1 192.168.100.250 "trap_user2" 162
CLI> delete snmp-trap -trap-number 2-4
CLI> show snmp-trap
Trap SNMP Manager IP Community User Port
No. Version Number Address Name Name Number
1 v1 1 192.168.100.250 "community1" 162
5 v3 1 192.168.100.250 "trap_user2" 162