Fujitsu Eternus DX90 S2 - Show Lcd-Suppress

Chapter 4 Function/System Settings and Display
4.3 Network Management > show lcd-suppress
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
526
show lcd-suppress
This command displays the information on LCD suppression. This command can only be used for the ETERNUS
DX8700 S2.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show lcd-suppress
CLI> show lcd-suppress
Parts Error [Display
]
A
Parts Warning [Suppress]
B
Disk Error [Display (HS<0)
]
C
Disk Warning [Display
]
D
A: It shows whether error display for the components (other than drives) is displayed on the LCD.
Display: Displayed
Suppress: Not displayed
B: It shows whether warning display for the components (other than drives) is displayed on the LCD.
Display: Displayed
Suppress: Not displayed
C: It shows whether error display for the drives is displayed on the LCD.
Display: Displayed
Suppress: Not displayed regardless of the number of hot spares left
Display (HS<0): Not displayed when hot spares are left
D: It shows whether warning display or the drives is displayed on the LCD.
Display: Displayed
Suppress: Not displayed regardless of the number of hot spares left
Display (HS<0): Not displayed when hot spares are left
The following example displays the information on LCD suppression:
CLI> show lcd-suppress
Parts Error [Display]
Parts Warning [Suppress]
Disk Error [Display (HS<0)]
Disk Warning [Display]