Fujitsu Eternus DX90 S2 - Show Syslog-Notification

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > show syslog-notification
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
582
show syslog-notification
This command displays settings of the syslog server association.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show syslog-notification
# Server1 function Enable (RFC3164)
A
# Server1 10.21.134.198
B
# Server1 Port Number 514
C
# Server1 Port MNT
D
# Server2 function Enable (RFC5424)
E
# Server2 10.17.80.6
F
# Server2 Port Number 517
G
# Server2 Port RMT
H
A: It shows whether syslog server 1 is enabled.
B: FQDN or IP address (IPv4 or IPv6) of the syslog server 1
C: UDP port number of the syslog server 1 for the syslog protocol
D: It shows which port is used.
E: It shows whether syslog server 2 is enabled.
F: FQDN or IP address (IPv4 or IPv6) of the syslog server 2
G: UDP port number of the syslog server 2 for the syslog protocol.
H: It shows which port is used.
The following example displays the settings of the syslog servers:
CLI> show syslog-notification
Server1 Function [Enable (RFC3164)]
Server1 [10.21.134.198]
Server1 Port Number [514]
Server1 Port [MNT]
Server2 Function [Enable (RFC5424)]
Server2 [10.17.80.6]
Server2 Port Number [517]
Server2 Port [RMT]