Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > show audit
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
586
show audit
This command displays the settings of the audit log functions.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show audit
# Audit Log Enable
A
# Server1 function Enable (RFC3164)
B
# Server1 10.21.134.198
C
# Server1 Port Number 514
D
# Server1 Port MNT
E
# Server2 function Enable (RFC5424)
F
# Server2 10.17.80.6
G
# Server2 Port Number 517
H
# Server2 Port RMT
I
A: It indicates whether the audit log function is enabled.
B: It indicates whether syslog server 1 is enabled.
C: FQDN or IP address (IPv4 or IPv6) of the syslog server 1
D: UDP port number of the syslog server 1 for the syslog protocol
E: It indicates which port is used.
F: It indicates whether syslog server 2 is enabled.
G: FQDN or IP address (IPv4 or IPv6) of the syslog server 2
H: UDP port number of the syslog server 2 for the syslog protocol
I: It indicates which port is used.
The following example displays the settings of the audit log function:
CLI> show audit
Audit Log [Enable]
Server1 Function [Enable (RFC3164)]
Server1 [10.21.134.198]
Server1 Port Number [514]
Server1 Port [MNT]
Server2 Function [Enable (RFC5424)]
Server2 [10.17.80.6]
Server2 Port Number [517]
Server2 Port [RMT]
To Next Page
Loading...
