Chapter 2 Status Display
2.1 Storage System Status > show disks
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
64
show disks
This command displays the details and status of the disk. As an option, an enclosure (all disks contained in
the specified enclosure), specific disks, or all the undefined disks can be specified.
■ Syntax
■ Parameter
■ Output
show disks [ -type {undefined | ce | de -de
enclosure_number
} | -disks {
disks
| all | productid} ]
-type Optional. This parameter specifies which disk information will be displayed. This parameter
cannot be specified with the "-disks" parameter. If all of the parameters are omitted, all disks
registered in the system will be displayed. undefined
undefined All the undefined disks
ce All disks in the controller enclosure (only for the ETERNUS DX80 S2/DX90 S2)
de All disks in the specified drive enclosure
When using this parameter, the "-de" parameter and the drive enclosure number
must also be specified.
-de Optional. This parameter specifies the number of the drive enclosure for which details are to be
obtained. This parameter cannot be used for other category types.
-disks Optional. This parameter specifies which disk number to display the detailed information of
the disk for. One or more parameters can be specified. For details, refer to "1.2.3 Disk Syntax"
(page 19) Specifying "all" will display the details of all disks. When using the "productid"
parameter, the product ID list of all disks is displayed. This function is useful when updating
disk firmware.
all Details of all disks
productid The Product ID list of all disks
For summary, the following items are displayed.
Location Disk slot number
Status Disk status
Size Disk capacity
Type Disk type
Speed Rotating speed (unit: rpm)
Usage Disk usage
Example: Data, Spare, System, etc.
To Next Page
Loading...
