Fujitsu Eternus DX90 S2 - Clear Disk-Error

Chapter 5 Information Settings and Display
5.3 Maintenance > clear disk-error
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
651
clear disk-error
This command clears the disk error information. It is possible to clear the error information of specific disks.
■ Syntax
■ Parameter
■ Example(s)
clear disk-error [-disks disks ]
-disks Optional. This parameter specifies the disks to clear the error information from. One or more
disks can be specified at the same time. For details, refer to "1.2.3 Disk Syntax" (page 19)
. If
this parameter is omitted, the error information for all the disks is cleared.
The following example clears the error information for all the disks:
CLI>clear disks-error
The following example clears only the error information for disk#1 in the CE:
CLI>clear disks-error -disks 001