Chapter 5 Information Settings and Display
5.4 Utility > set led
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
666
set led
This command turns the specified LED(s) either on or off.
■ Syntax
■ Parameter
■ Example(s)
set led -target { ce | disk | svc0 | svc1 | opnl } [ -disks
disks
] -led { on | off }
-target This parameter specifies which enclosure will have all of the LEDs turned on or off.
When "-target disks" is specified, the "-disks" parameter must also be specified.
ce All components in the controller enclosure
disk Only the specified disks
svc0 Only SVC#0 (Only for ETERNUS DX8700 S2)
svc1 Only SVC#1 (Only for ETERNUS DX8700 S2)
opnl Only the operation panel (Only for ETERNUS DX8700 S2)
-disks Optional. This parameter specifies which disks LED are turned on or off. Multiple disks can be
specified at the same time. For details, refer to "1.2.3 Disk Syntax" (page 19)
.
-led This parameter specifies whether the specified LEDs are turned on or off.
on Turn on the LED
off Turn off the LED
The following example turns on the LEDs of all the components in DE#1:
CLI> set led -target disk -disks 001,002 -led on
To Next Page
Loading...
