Fujitsu Eternus DX90 S2 - Create Thin-Pro-Pool

Chapter 3 Configuration Settings and Display
3.1 Thin Provisioning Pool Management > create thin-pro-pool
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
74
create thin-pro-pool
This command creates a Thin provisioning pool with the specified Thin provisioning pool name, disk attribute,
reliability, encryption, and a RAID group. The Thin provisioning pool is formatted automatically after it is
created. When registering a hot spare, refer to the "set global-spare" or the "set dedicated-spare" command.
■ Syntax
■ Parameter
create thin-pro-pool -name alias_name -attribute {online|nearline|ssd|sed}
-level {0|1|5|6|10} [-warning
warning ] [-attention attention ]
-rg-mode {auto|manual} [-capacity capacity] [-disks
disks ]
[-assigned-cm {0|1|cm0cpu0|cm0cpu1|cm1cpu0|cm1cpu1|cm2cpu0|cm2cpu1|cm3cpu0|cm3cpu1|
cm4cpu0|cm4cpu1|cm5cpu0|cm5cpu1|cm6cpu0|cm6cpu1|cm7cpu0|cm7cpu1| auto}]
[-encryption {enable|disable}] [-stripe-depth { 64kb | 128kb | 256kb | 512kb | 1024kb }]
-name This parameter specifies the alias name of a Thin provisioning pool. Only one name can be
specified. For details, refer to "1.2.4 Alias Name Syntax" (page 20)
.
-attribute This parameter specifies the disk attribute of a Thin provisioning pool.
online Online disks
nearline Nearline disks
ssd SSDs
sed SEDs
-level This parameter specifies the RAID level.
0RAID0
1RAID1
5RAID5
6RAID6
10 RAID1+0
-warning Optional. This parameter specifies the warning level of the Thin provisioning pool. The settable
range is 5 – 99%. If this parameter is omitted, the default value (90%) is set. The warning level
range should be equal to or higher than the "-attention" setting range.
-attention Optional. This parameter specifies the attention level of the Thin provisioning pool. The
settable range is 5 – 80%. If this parameter is omitted, the default value (75%) is set. The
attention level range should be equal to or lower than the "-warning" setting range.
-rg-mode This parameter specifies the method of selecting the disk when creating the RAID group.
auto The disk is automatically allocated. The capacity of the disk is specified with the -
capacity parameter.
manual The disk is manually allocated. The disk is specified with the -disks parameter.