Fujitsu Eternus DX90 S2 - Page 751

Appendix E Default Value List
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
751
set iscsi-parameters isns-server-port 3205
chap disable
header-digest disable
data-digest disable
jumbo-frame disable
rate 1 Gbit/s (1Gbit/s iSCSI)
10 Gbit/s (10Gbit/s iSCSI)
cmdsn-count unlimited
vlan-id disable
vlan-id-value 0
mtu 1300
bandwidth 400 Mbit/s
chap-ca disable
chap-ra disable
rec-line-no 0
rec-transfer-sync enable
rec-transfer-stack enable
rec-transfer-consistency enable
rec-transfer-through enable
set fcoe-parameters host-affinity disable
rate 10Gbit/s
frame-size 2048
reset-scope initiator-lun
reserve-cancel disable
fcf-vlan-id disable
fcf-vlan-id-value 0
fcf-fabric-name disable
fcf-fabric-name-value 0
set host-response status unit-attention
inquiry-byte0 disable
vpd type3
conflict disable
timeout 25 seconds
version 5
host-specific-mode normal
symmetric passive (ETERNUS DX80 S2/DX90 S2, ETERNUS
DX410 S2/DX440 S2, and ETERNUS DX8100 S2)
active (ETERNUS DX8700 S2)
lun-change disable
lun-expand disable
vendor-unique-sense disable
iscsi-disc-rsp all
tpgs enable
Command Parameter Default value