Fujitsu Eternus DX90 S2 - Thin Provisioning Pool ECO Management

Chapter 3 Configuration Settings and Display
3.1 Thin Provisioning Pool Management
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
86
3.1.2 Thin Provisioning Pool ECO Management
This section explains the commands that are related to the ECO functions of a Thin provisioning pool. They are
only applicable when the ECO mode is enabled using the "set eco-mode" command.
The three steps involved in enabling the ECO functions are as follows:
Procedure
1 Enable the ECO mode.
2 Create an ECO schedule.
3 Assign the ECO schedule to Thin provisioning pools.
End of procedure
For the ECO mode and ECO schedule settings, refer to "3.3.3 ECO Management" (page 128).
■ Summary of Thin provisioning pool ECO settings through CLI
Setting of the Thin provisioning pools (TPP) with ECO using CLI are as follows:
Procedure
1 Assign the ECO mode to a TPP.
To assign an ECO mode schedule to TPP, use the "set eco-thin-pro-pool" command.
To check the ECO mode schedule, use the "show eco-thin-pro-pool" command. An ECO mode schedule
can be released from an assigned TPP by using the "release eco-thin-pro-pool" command.
End of procedure
The following figure shows Thin provisioning ECO setting management:
release eco-thin-pro-pool
(Release associated ECO schedule)
TPP (Thin Provisioning Pool)
eco schedule
every-day
10:00 - 20:00
set eco-thin-pro-pool
(Associate ECO schedule)
create eco-schedule
(Create ECO schedule)
show eco-thin-pro-pool
(Show associated ECO
schedule)