Fujitsu Eternus DX90 S2 - Show Flexible-Tier-Mode

Chapter 3 Configuration Settings and Display
3.2 Flexible Tier Management > show flexible-tier-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
92
show flexible-tier-mode
This command displays the setting status of the Flexible Tier function.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show flexible-tier-mode
# Flexible Tier Mode [Enable]
A
A: It shows whether the Flexible Tier function is enabled.
The following example displays the setting status of the Flexible Tier function:
CLI> show flexible-tier-mode
Flexible Tier Mode [Disable]
CLI> show flexible-tier-mode
Flexible Tier Mode [Enable]