Fujitsu Eternus DX90 - Specific Settings; Setting the Reset Groups

To Next Page

To Previous Page

2.2 Specific Settings

Some settings are not required for some OSes and/or connection configurations.

Check the various cases described below, and perform any required settings.

2.2.1 Setting the Reset Groups

If the system configuration matches any of the items "System configuration that requires the reset group set-

ting" in the following table, every ETERNUS DX port that connects to the given server's access paths must be

assigned to the same reset group.

For system configurations other than the following, use the default settings.

System configuration that requires the reset group setting

Solaris OS Cluster configuration

AIX Single path configuration using FJspio for a PowerHA or HACMP cluster

Windows Server

2003

MSCS configuration (*1)

VMware vSphere (ESXi 5.5, ESXi 5.1, ES-

Xi 5.0, ESX 4.1, ESXi 4.1, ESX 4.0, ESXi

4.0)

VMware Infrastructure 3 (ESX 3.5, ESXi

3.5)

Multipath configuration

Multiple ESX servers share ETERNUS DX LUNs (*2)

*1: For a Windows Server

2012 R2, Windows Server

2012, Windows Server

2008 R2, or Windows Server

2008 based WSFC configuration, the reset group settings are not necessary.

Chapter 2 Setting Up the ETERNUS DX

2.2 Specific Settings

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

P3AM-3182-15ENZ0

Other manuals for Fujitsu Eternus DX90