Chapter 1
Workflow
This manual is used when performing the setup procedures described in the "Setting Up the ETERNUS DX"
section of the "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel)" for
each OS.
Required Documents
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Channel
Switch Settings"
•
"Converged Enhanced Ethernet Administrator's Guide"
•
"Fabric OS Administrator's Guide"
•
"FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris"
•
"ETERNUS Web GUI User's Guide"
Workflow
Setting the FC Port Parameters
Set the to-server connection type.
•
"2.1.1 Setting the To-server Connection Type (Setting the FC Port Parameters)" (page 8)
Setting the Host Responses
Set the host responses to match the connection configuration.
•
"2.1.2 Sense Data Conversion (Setting the Host Responses)" (page 9)
Setting the FC Host
Register the WWNs of the accessing Fibre Channel cards or Converged Network Adapter cards.
•
"2.1.3 Registering the WWNs of the Accessing Fibre Channel Cards or Converged Network Adapter
Cards (Setting FC Host)" (page 11)
6
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
P3AM-3182-15ENZ0
To Next Page
Loading...
