Fujitsu Eternus DX90 - Chapter 2 Setting up the ETERNUS DX; Common Settings; Setting the To-Server Connection Type (Setting the FC Port Parameters); Table 2.1 FC Port Parameter Settings (FC-AL Connection)

To Next Page

To Previous Page

Chapter 2

Setting Up the ETERNUS DX

2.1 Common Settings

This section explains the settings required for all server OSs, regardless of the connection configuration.

See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.

2.1.1 Setting the To-server Connection Type (Setting the FC Port Parameters)

For each connection configuration, set the indicated items only. Retain the default values for all of the pa-

rameters that are not described below.

Table 2.1 FC port parameter settings (FC-AL connection)

Parameter

Solaris OS

HP-UX, AIX, Windows

, Linux, VMware

ESX, PAN Manager, Citrix XenServer,

Oracle Linux, Oracle VM Server

Connection FC-AL

Set Loop ID Manual

Loop ID (*1) Values from 0x10 upwards (except

0x7D)

0x00

Frame Size 2048 bytes (Default value)

Transfer Rate See the table below (*2)

Host Affinity Enable

Reset Scope I_T_L (Default value)

Release Reservation if Chip is Reset Disable (Default value)

*1: Assign Loop IDs that are unique within each Loop, in ascending order.

*2: Set the appropriate value from the following table. Do not use [Auto].

Table 2.2 Transfer rate setting values

Fibre Channel card maximum speed

Transfer rate setting value

8Gbit/s CA 4Gbit/s CA

8Gbit/s 8Gbit/s 4Gbit/s

4Gbit/s 4Gbit/s 4Gbit/s

2Gbit/s 2Gbit/s 2Gbit/s

1Gbit/s — 1Gbit/s

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

P3AM-3182-15ENZ0

Other manuals for Fujitsu Eternus DX90