Fujitsu Eternus DX90 - Installing AC Outlet Box (2 U)

Chapter 5 Installation
> 5.2 Rack Installation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
102
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
- Attachment procedure
5-2 Attach the blank panel to the rack pillars using two black M5 screws.
End of procedure
5.2.4 Installing AC Outlet Box (2U)
This section describes how to install the 2U AC outlet box in a rack.
M5 cage nut
Clip the cage nut tabs into the desired
hole from the inside.
M5 rack nut
Clip the rack nut over the desired
hole from the side.
Side view
Rack pillar (round)
M5 Rack nut
M5 cage nut
Rack pillar (square)
(Rear rack pillars)
(Front rack pillars)
Blank panel
M5 screw
M5 screw
AC outlet box
CAUTION
D
o N
ot
• AC outlet box cannot be connected to the device other than
ETERNUS DX60/DX80/DX90.