Chapter 6 Cable Connection
> 6.5 MiniSAS Cable Connection (For SAS)
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
116
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
■ MiniSAS cable connection procedure
The following explains how to connect the miniSAS cable.
Procedure
1 Connect the miniSAS cables to the ETERNUS DX60/DX80.
Insert the miniSAS cable connectors in the controller 0 (CM#0) and controller 1 (CM#1)
SAS ports.
• To help with miniSAS cable management and prevent incorrect
connections, attach labels to the miniSAS cables and make a note of
connection origins and destinations.
• When connecting miniSAS cables, check the connector orientation and
then firmly push it all the way in.
When disconnecting miniSAS cables, use the pull-tab to extract the
connector.
Do not connect this cable to the SAS (OUT) port.
miniSAS cable
tab
To Next Page
Loading...
