Fujitsu Eternus DX90 - Disk Installation Positions; Additional Disk Installation Procedure

Chapter 8 Installing Optional Products
> 8.1 Disk Installation
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
185
Copyright 2010 FUJITSU LIMITED
P3AM-3042-06ENZ0
8.1.3 Disk Installation Positions
This section explains the disk installation positions.
• 3.5" disks
3.5" disks can be installed in the front of the 3.5" type controller enclosure or 3.5" type drive
enclosure, as shown in Figure 8.1
.
Figure 8.1 Position of 3.5" disk slots
• 2.5" disks
2.5" disks can be installed in the front of the 2.5" type controller enclosure or 2.5" type drive
enclosure, as shown in Figure 8.2
.
Figure 8.2 Position of 2.5" disk slots
8.1.4 Additional Disk Installation Procedure
This section describes how to install additional disks in the ETERNUS DX60/DX80/DX90.
Slot#0
Slot#4
Slot#8
Slot#1
Slot#5
Slot#9
Slot#2
Slot#6
Slot#10
Slot#3
Slot#7
Slot#11
Slot#8 Slot#9
Slot#10
Slot#11
Slot#12 Slot#13 Slot#14 Slot#15
Slot#0 Slot#1 Slot#2 Slot#3 Slot#4 Slot#5 Slot#6 Slot#7
Slot#16 Slot#17 Slot#18 Slot#19 Slot#20 Slot#21 Slot#22 Slot#23
WARNING
D
o N
ot
• Do not install any disks that are not FUJITSU authorized, as they
may damage the device and/or cause fire or electrical shock.
• Do not damage or modify the internal cables or ETERNUS DX60/
DX80/DX90 when installing the disks, as this may damage the
device and/or cause fire or electrical shock.
• Do not remove system disks. Doing so will render the ETERNUS
DX60/DX80/DX90 unusable.