ETERNUS JX40 S2 Operating Manual 11
Introduction Documentation Overview
● Installation
The activities needed to install and commission the storage subsystem are
described.
● Fault Clearing
This chapter contains advice on solving problems that occur on
commissioning or during the operation of the storage subsystem.
● Replacing Components
This part of the manual describes the fitting and removing of power supply
units and I/O modules.
1.3 Documentation Overview
More information on the subsystem can be found in the following documents:
● “SETUP ETERNUS JX40 S2 SAS 2.5" / 3.5" HDD” leaflet
“
はじめにお読みく ださい ” for the Japanese market (only included as a
printed copy)
● “Safety notes and other important information” manual
“ 安全上のご注意 ” for the Japanese market
● “Warranty” manual
“
保証書 ” for the Japanese market
To Next Page
Loading...
