Fujitsu ETERNUS JX40 S2 - Introduction

ETERNUS JX40 S2 Operating Manual 9
1 Introduction
The functionality, mechanics and design of the ETERNUS
®
JX40 S2 storage
subsystem are optimally adapted to the servers of Fujitsu Technology Solutions.
It is designed to be used as rack model. In the 19-inch rack, the
ETERNUS JX40 S2 subsystem occupies two height units.
The ETERNUS JX40 S2 storage subsystem can accommodate drives and
SSDs as follows:
A maximum of four ETERNUS JX40 S2 storage subsystems can be daisy-
chained in a connection to one RAID controller/HBA port.
Server Management/ServerView
(Only for connection to PRIMERGY servers and ServerView Suite package)
ServerView and the related agents are set up within the group of servers and
storage subsystems being monitored. The received informations are evaluated
by ServerView and processed for display or forwarding to the administrator
(manager).
I When installing ETERNUS JX40 S2 storage subsystem in connection
with ServerView please install the ServerView Suite V10.10.04 or higher
on each of the connected servers (will be implemented later).
Notes to installing and update see at the documentation of ServerView (see
also "Related Publications" on page 79).
2.5" Up to 24 drives including up to 4 SSDs
3.5" Up to 12 drives