Fujitsu ETERNUS LT20 S2 - SCDPM2012 Device Drivers; SCDPM2012 System Settings; Tuning Backup Performance

ETERNUS LT20 S2 67
Operating the LTO Library Remote Management Unit (RMU)
– IPv4 / IPv6 Target 2
– IPv4 / IPv6 Target 3
– IPv6 Community Name
– IPv6 Security User Name
– IPv6 SNMP Trap Notification Filter
Figure 51: Configuration, SNMP page
4.4.6.5 Changing the Administrative Password
This page allows the user to add and modify user accounts. You can reach this
page by selecting Configuration → User.
– Access Level – choose from 1 (Standard), 2 (Admin), or 3 (Service)
– Access Level Name – the name associated with the chosen Access Level
– New Password – the password can be a maximum of ten characters
– Repeat Password – enter the new password again
– OCP Access PIN Enabled – select this item, if you would like the Operator
Control Panel display to be password protected
– OCP Access PIN Code – the password for accessing the OCP when the
OCP Access PIN is enabled
– Repeat OCP Access PIN Code – enter the OCP Access PIN Code again
– Support Name – the name of the individual within your company to contact
for RMU or library support