Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to the PC.
[Device setting]
Item Explanation Selectable parameter Default
Page counter
(Consumables
counter)
For evaluating the
consumable replacement
cycle.
Use this function to reset
the counters after replacing
consumables.
Pick roller/Brake roller/remaining ink
level (only for the imprinter option)
—
Power saving setting Select the waiting time
before entering the Power
saving mode.
Setting range 15 to 55 minutes (set in
steps of 5 min.)
15 min.
Offset setting
Adjust the start position for
the document scanning.
Up down/Left right: setting range -2
to 2 mm (set in 0.5 mm steps)
Up down/
left right : 0
mm
Scan scale Adjust the magnification in
the feeding direction.
Setting range -3.1% to 3.1% (set in
0.1% steps)
0%
Device settings 2
file:////10.232.227.50/Manual/fi-6140_6240C-Lynx3/OG/R02/02_081030/contents/EN/08/c08_01_01.htm (2/5) [2008/10/30 12:42:39]
To Next Page
Loading...
