EasyManua.ls Logo

Fujitsu FI-6750S - Memory Upgrade Module

Fujitsu FI-6750S
182 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
U s e r I n s t a l l a b l e F e a t u r e s
L i f e B o o k 6 0 0 S e r i e s f r o m F u j i t s u
115
MEMORY UPGRADE MODULE
Your notebook has 32MB of installed SDRAM.
To increase your memory capacity you may
install a memory upgrade module in the memo-
ry upgrade compartment in the bottom of your
notebook.A memory upgrade module is a dual-
in-line memory module (DIMM). You may add
a module of different capacity. SDRAM memory
upgrade modules are recommended but EDO
Memory upgrade modules will work. Installing
an EDO Memory upgrade module will cause
your system to operate at a slower rate.
C A U T I O N
Never remove screws except the ones
specifically shown in the directions for
installing and removing the memory
upgrade module.
C A U T I O N
Pressing F10 while holding down the Fn
key allows you to change your selection
of where to send your display video.
Each time you press the combination
of keys you will step to the next choice.
The choices, in order, are: built-in display
panel only, external monitor only, both
built-in display panel and external
monitor, or TV.
Figure 4-13 Opening the Memory Upgrade Compartment
Figure 4-14 Installing a Memory Upgrade Module

Table of Contents

Other manuals for Fujitsu FI-6750S

Related product manuals