Chapter 6 Replacing the Consumables
Appendix
Glossary
Introduction
Index
Contents
TOP
108
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Scanner
Overview
Replacing the
Consumables
8 Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 21).
9 Attach the ADF paper chute (feeder).
Insert the tabs into the slots on the back of the scanner in the
direction of arrow and tilt the ADF paper chute (feeder)
downwards in the direction of arrow until it locks in place.
Attach the ADF paper chute (feeder) with the side guides facing
upwards.
10 Reset the pick roller counter.
Reset the counter by performing one of the following actions:
Reset the counter in [4: Consumable counters] on the [Settings
Menu] screen of the operator panel.
For details, refer to "3.2 Settings Menu" (page 55).
Reset the counter in the Software Operation Panel.
For details, refer to "Resetting the Sheet Counters" (page 160).
Be careful not to get your fingers caught
when closing the ADF.
ATTENTION
Do not leave any space between the ADF paper chute (feeder) and
the scanner.
ADF Paper Chute
(Feeder)
Tab
2
1
Side Guides
To Next Page
Loading...
