Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
156
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Number of paper feeding retries
(page 168)
Configure this setting to change the number of
feeding retries when a pick error occurs.
This setting can also be configured with the
operator panel.
1 to 12 times 3 times
Cleaning Cycle
(page 162)
Specify the scanner cleaning cycle.
Select whether or not to display the cleaning
instruction message from the scanner driver.
1,000 to 255,000 sheets
(in increments of 1,000)
[Show cleaning instructions] check box
5,000 sheets
Not selected
Life Counter Alarm Setting
(page 162)
Specify the replacement cycle for the
consumables.
Pick Rollers/Brake Rollers:
10,000 to 2,550,000 sheets
(in increments of 10,000)
Pick Rollers:
200,000 sheets
Brake Rollers:
200,000 sheets
Vertical Streak Detection
(page 186)
Select whether to enable or disable vertical
streak detection.
Enable to detect vertical streaks (dirt on the
glass) when you perform scanning with the
ADF.
This setting can also be configured with the
operator panel.
Enable/Disable Disable
Vertical Streak Sensitivity
(page 187)
Specify the sensitivity level to detect vertical
streaks (dirt on the glass) when vertical streak
detection is enabled.
This setting can also be configured with the
operator panel.
Low/Normal/High Normal
Pick Speed
(page 169)
When multifeeds and paper jams occur
frequently, you may be able to improve the
performance by slowing down the speed in
which documents are picked or fed.
This setting can also be configured with the
operator panel.
Normal/Slow Normal
AutoCrop Boundary
(page 170)
Specify whether or not to optimize (round up/
down) the fractional part of the scanned image
data.
Optimize/Round Down Optimize
Item Description Parameter/Value Factory Default
To Next Page
Loading...
