Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
157
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Manual Feeding
(page 182)
Select whether to enable or disable the
continuous feed mode.
This setting can also be configured with the
operator panel.
Disable/Enable Disable
Timeout Time: Specify the waiting time for the
scanner to cancel manual feeding.
This setting can also be configured with the
operator panel.
5, 10, 20, 30, 40, 50, 60, 70, 80, 90, 100, 110
(seconds)
10 seconds
Power SW Control
(page 185)
Specify the method by which the scanner is
powered on/off.
Enable power switch/Disable power switch/
Enable USB power feeding
Enable power
switch
Paper Protection
(page 171)
Select a paper protection detection method.
This function can reduce the risk of having the
documents damaged by detecting a feeding
error and stopping the scan in the following
cases:
When the scanner detects a document that
was unusually warped by a feeding error
When the scanner detects paper jam noise
When the scanner either detects a
document that was unusually warped by a
feeding error or detects paper jam noise
This setting can also be configured in the
scanner driver or with the operator panel. When
the operator panel setting is prioritized, the
operator panel setting is prioritized over the
Software Operation Panel setting. Note that
even if the operator panel setting is prioritized,
the scanner driver setting has the highest
priority.
Disable/Feeding Accuracy/Feeding Noise/
Feeding Accuracy & Noise
Feeding
Accuracy
Item Description Parameter/Value Factory Default
To Next Page
Loading...
