Chapter 8 Operational Settings
Appendix
Glossary
Introduction
Index
Contents
TOP
188
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Operational
Settings
Scanner Maintenance and Inspection Cycle
[Maintenance and Inspection Cycle]
Specify a cycle for the regular maintenance and inspection
that is performed on the scanner by a service engineer.
When the specified period has passed after the last regular
maintenance and inspection date, flashes on the
LCD.
In this case, [maintenance] flashes on the second line in the
[Ready] screen.
Check the information and perform a regular maintenance and
inspection on the scanner by a service engineer.
For details about checking the information, refer to "Checking
the Information" (page 60).
For regular maintenance and inspection on the scanner by a
service engineer, contact your FUJITSU scanner dealer or an
authorized FUJITSU scanner service provider.
1 Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 143).
2 From the listing on the left, select [Device Setting 2]
[Maintenance and Inspection Cycle].
3 Select whether to enable or disable [Maintenance and
Inspection Cycle].
If you select [Enable], select a cycle for the regular maintenance and
inspection that is performed on the scanner by a service engineer.
To Next Page
Loading...
