How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
68
How to Load
Documents
Scanner
Overview
10: Low-speed
Feed Mode
Specify whether or not to reduce the scanning
speed to prevent paper damage.
This setting can also be configured from the
Software Operation Panel.
1: Enable
2: Disable
2: Disable
11: Doc Counting
Mode
You can count the number of scanned documents in
Doc Counting Mode.
--
12: iMFF Setting When there is a paper of the same size attached to
a designated location on the page, you can
configure the scanner to memorize the location of
the attachment and not detect multifeeds for that
location.
Note that you need to specify [Check Overlapping
(Ultrasonic)] in either the scanner driver or the
multifeed detection setting in "Specifying a
Multifeed Detection Method [Multifeed]" (page 176)
beforehand.
By selecting [4: Clear pattern], you can clear the
overlapping patterns (length, location) that were
previously memorized in Auto mode.
This setting can also be configured from the
Software Operation Panel.
1: Manual mode
2: Auto mode 1
3: Auto mode 2
4: Clear pattern
1: Manual
mode
13: No. of Paper
Feed Retries
Configure this setting to change the number of
feeding retries when a pick error occurs.
This setting can also be configured from the
Software Operation Panel.
1 to 12 (times) 3
14: Manual/
Continuous Feed
Setting
Select whether to enable or disable the continuous
feed mode.
This setting can also be configured from the
Software Operation Panel.
1: Enable
2: Disable
2: Disable
Item Description Parameter (*1)/Value Factory
Default
(*2)
-: No parameters/values
To Next Page
Loading...
