Fujitsu fi-7460 - Item Configurable in Function Selection

How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Chapter 3 How to Use the Operator Panel
Appendix
Glossary
Introduction
Index
Contents
TOP
74
How to Load
Documents
Scanner
Overview
Item Configurable in Function Selection
*1: Although there is no factory default setting, it is set to [No.00] when you turn on the power. The settings do not change even when you initialize the
operator panel because there is no factory default setting.
Item Description Setting Factory
Default
Function
Selection
Configure the application you want to launch when you press the
[Scan/Enter] button while the [Ready] screen is displayed.
It displays the scanner button events configured in the computer
([Scan Button]/[Send to 1] to [Send to 50]).
For "No.00", the event for [Scan Button] is displayed.
For [No.01] to [No.50], the events for [Send to 1] to [Send to 50]
are displayed.
For information on how to configure scanner button events, refer
to "Using a Button on the Scanner to Start Scanning" (page 84).
No.00 to No.50/SOP
(SOP indicates the Software Operation
Panel)
(*1)