How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Daily Care
Operational
Settings
Chapter 5 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
98
How to Load
Documents
Scanner
Overview
Brake Roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to "6.2 Replacing the
Brake Roller" (page 103).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick Roller (× 2)
Gently wipe off any dirt or dust along the grooves as you rotate the roller
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Rubber Roller (× 4)
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Be careful not to damage the sponge that is attached to the roller.
Glass (× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
Ultrasonic Sensor (× 2)/Document Sensor (× 8)
Gently wipe the dirt and dust off the surface of the ultrasonic/document
sensors.
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
HINT
If it is difficult to clean, use a cotton swab.
Ultrasonic Sensor
Document Sensor
To Next Page
Loading...
