Fujitsu fi-7800 - Cleaning the ADF (with Cleaning Sheet)

Cleaning the ADF (with Cleaning Sheet)
Use the Cleaning Sheet to clean the rollers on both the upper and lower sides of the paper path.
For more details about the Cleaning Sheet, refer to Cleaning Materials (page 115).
Cleaning with the Cleaning Sheet
1 Press the power button on the front of the scanner.
[Ready] is displayed on the LCD.
2 Press the [Menu] button.
[Main Menu] is displayed on the LCD.
3 Press the [ ] or [ ] button and select [21: Cleaning], then press the [Function/Enter] button to
confirm.
[Cleaning] is displayed on the LCD.
4 Press the [
] or [ ] button and select [1: Sheet], then press the [Function/Enter] button to confirm.
A message is displayed on the LCD.
ATTENTION
Do not start scanning with an image scanning application during cleaning.
5 Set the width of the hopper side guides to B4.
For details, refer to Loading Documents (page 47).
6 Adjust the stacker extension to the length of the Cleaning Sheet, and pull up the paper stop.
For details, refer to Setting Up the Stacker (page 33).
7 Remove the protective paper from the Cleaning Sheet.
Daily Care
118