c. Press the [Scan/Stop] button for 3 seconds or more in order for the
scanner to enter cleaning mode.
d. Press the [Scan/Stop] button.
The feed/eject rollers rotate a certain amount simultaneously.
As a guideline, pressing the [Scan/Stop] button seven times will
rotate the feed rollers/eject rollers one revolution.
e. Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the surface of the rotating feed/eject roller,
and wipe horizontally to clean dirt and dust off the whole surface.
Make sure that it is wiped properly because black residue on the
roller will affect the feeding performance.
5. Close the ADF.
6. Clear the sheet counter after cleaning.
Start up the Software Operation Panel and clear the counter.
To Next Page
Loading...
