48 U41578-J-Z875-1-76
RAID wizard
This display shows that some of the LUN have not yet been assigned to a port.
This example shows that HBA1 on your administration PC is activated and has
access to the LUNs no. 0, no. 2, no. 4. HBA1 cannot access LUNs no. 1 and
no. 3. LUNs no. 1 and no. 3 are not visible over the HBA and you cannot
therefore access LUN 1 and 3 using this HBA.
Use the ALL function to select the entire row of HBAs at the same time.
The selected HBA is marked green, the connected, but not selected HBA’s are
marked yellow. Earlier connected HBA’s, which are not actually connected, are
marked red. There are up to 256 different HBA’s possible.
Click Next to confirm your settings.
A complete list of all your configuration settings will now be displayed on screen.
Check that these are correct. If they are correct, click the Finish button. If they
are not correct, use the Back button to work backwards through the configu-
ration procedure and correct the configuration settings where necessary and
using the methods described previously.
To Next Page
Loading...
