Fujitsu FP-510II - Page 110

109 / 125
Example (4) Initializing the printer settings
Note on initialization
The initialization procedure does not initialize the paper width.
The initialization procedure is as follows:
1. Before starting work for this setting, verify the following printer conditions:
(1) The power is turned off.
(2) Paper is loaded on the printer.
(3) The cover is closed.
2. Enter special mode.
Turn on the power switch on the right side of the printer while holding
down the FEED switch on the left part of the top cover.
The printer prints the following when entering special mode:
TEST PRINT
ITEM SELECTION :FEED switch pushed short.
ITEM DECSION :FEED switch pushed short.
SPECIAL MODE
Paper feed direction
END
SAMPLE PRINT
CUTTER CLEANING
PLATEN ROLLER CLEAING
SET UP
HEX DUMP
TEST PR
INT
SELECTION ITEM