68
- Device Ports
Figure 34. Connecting a USB Device
USB 2.0 Port
USB 2.0 Port
with Anytime USB Charge capability
Anytime USB Charge Utility
The Anytime USB Charge feature can be disabled
and enabled from the BIOS Setup Utility; the
feature is enabled by default. The settings for the
Anytime USB Charge feature can be changed by
going to Start > All Programs > Anytime USB
Charge Utility and clicking on Settings. There are
three possible settings for this feature: “Disable
Anytime USB Charge function”, “Only enable
Anytime USB Charge function with AC Adapter”,
and “Enable Anytime USB Charge function with
AC Adapter or battery”. Note that if the setting is
selected, the function will eventually drain the
battery if the AC Adapter is not plugged in.
Certain USB devices may require that a driver be
installed in order for this feature to work. Please
check the documentation for your USB device to
ensure proper charging with the Anytime USB
Charge utility.
To Next Page
Loading...
