104
LifeBook B Series – Appendix
Other computers are
not displayed when
the [Network
Computer] icon is
double-clicked.
The TCP/IP protocol
is not installed, or,
the IP address is not
set correctly.
If the TCP/IP protocol is installed, do the following to check the IP
address:
1. Windows 98:
Click [Start] -> [Programs] -> [MS-DOS Prompt].
Windows 2000:
Click [Start] -> [Programs] -> [Accessories] -> [Command
Prompt].
Windows XP:
Click [Start] -> [All Programs] -> [Accessories] -> [Command
Prompt].
2. Enter “IPCONFIG” command, and press [Enter].
(If your hard disk is C drive, enter
C:\>ipconfig)
Check that the IP address is correctly displayed under the IP Address.
Example:
IP address: 10.0.1.3
Subnet Mask: 255.255.255.0
Default Gateway: 10.0.1.1
No communication
due to poor radio
signal.
Shorten the distance between computers or remove visible obstacles
between them, and retry the connection.
Problem Possible Cause Possible Solution
B Series.book Page 104 Thursday, April 11, 2002 4:34 PM
To Next Page
Loading...
