Manufacturer’s no tes
CE marking
CEmarking
CE marking f or devices with radio component
This equipmen t complies with the requirements of Directive 1999/5/EC of the
European Parliament and Commission from 9 March, 1999 gove rning Radio
and Telecommunications Equipment and mutual recognition of conformity.
This equipment can be used in the following countries:
Belgium Bulgaria Denmark
Germany
Estonia Finland France
Greece
UK Ireland Iceland Italy
Latvia Liechtenstein Lithuania Luxemb ourg
Malta The
Netherlands
Norway Austria
Poland Portugal Rumania
Sweden
Switzerland Slovakia Slovenia Spain
Czech Republic
Hungary
Cyprus
Contact the corresponding government office in the respective co untry for
current information on possible op erating restrictions. If your country is
not included in the list, th en please contact the corresponding supervisory
authority as to whether the use of this product is permitted in your country.
Regulatory notices
If there is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Communications Commission (FCC ) of the USA.
Although it is not explicitly forbidden to travel in the US trading a rea carrying this
device, to avoid trouble at customs clearance, F ujitsu Technology Solutions GmbH
recommends not to bring this device into the US trading area.
Regulatory information for no tebooks without radio device
Regulatoryinf ormation
NOTICE:
Changes or modifications not expressly approved by Fujitsu Technology S olutions
could void this user ’s authority to operate the equipment.
Notice to Users o f Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance w ith the instructions, may cause harmful interference
to radio comm unications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and o n, the user is encouraged
to try to correct the i nterferen ce by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
70 Fujitsu Technology S olutions
To Next Page
Loading...
