45
- Quick Point Pointing Device/Touch Screen
Calibrating the Touch Screen
In order to ensure accurate tracking between the stylus and cursor, you must run the Touch Screen
Calibration Utility before you use the Touch Screen for the first time, or after you change the display
resolution.
To run the calibration utility:
1 Go to Start > Control Panel. If you are not in Classic View, select “Switch to Classic View” in the left panel.
Double-Clicking
To double-click, touch the item twice, and then
immediately remove the stylus tip. You also have the
option to perform the double-click operation by
tapping your finger twice lightly on the Touch Screen.
Figure 20. Double-clicking the Touch Screen
Dragging
Dragging means moving an item with the stylus by
touching the screen, moving and then lifting the stylus.
To drag, touch the Touch Screen with your stylus on
the item you wish to move. While continuing to touch
the screen with the stylus, drag the item to its new
location by moving the stylus across the screen, and
then lifting the stylus to release it. Dragging can also
be done using your fingertip.
Figure 21. Dragging on the Touch Screen
To Next Page
Loading...
