74
- Device Ports
Universal Serial Bus Ports
In order to connect a USB device, follow these steps:
1 Align the connector with the port opening.
1 Push the connector into the port until it is seated.
DisplayPort
The USB 2.0 ports allow you to connect Universal
Serial Bus devices. USB 2.0 transfers data at up to
480 Mbps and is backward-compatible with USB
1.1 devices, which transfer data at up to 12 Mbps.
There is one USB 2.0 port on the left side of the
system and two USB 2.0 ports on the right. Note that
the USB port on the left side of the system has
Anytime Charge capability, meaning you can charge
an external device from this port, even when the
system is powered down.
Figure 31. Connecting a USB Device
The DisplayPort lets you to connect DisplayPort-
compatible digital display devices such flat panel
displays and digital projectors using a DisplayPort
cable.
To connect a DisplayPort device:
1 Align the connector with the port opening.
2 Push the connector into the port until it is seated.
Figure 32. Connecting a DisplayPort Device
To Next Page
Loading...
